Polycarbonate Skylights

Sky Lighting • Side Lighting • Ridge Lighting

SunSky corrugated polycarbonate panels stand up to punishing exterior applications and offer multiple advantages over traditional fiberglass corrugated panels. SunSky provides up to 20 times greater impact resistance, warranted protection against yellowing, excellent load ratings, and the highest resistance to wind uplift–outstanding properties confirmed by independent laboratory tests and in installations worldwide since 1984. SunSky is available in soft white for maximum light transmission without glare, as well as clear and a range of colors to filter light or reduce heat loads.

NOTICE: To prevent cracking caused by expansion and contraction, all skylights should be pre-drilled. For panels longer than 12’, pre-drill panels at all fastening points with a 3/8” hole to allow for increased expansion and contraction due to longer length. For panels 12’ in length or less, pre-drill a hole 1/16” larger than the diameter of the fastener shank. Palram recommends that SunSky panels are not installed below 40°F or above 80°F. For best results, use screws designed for polycarbonate with a 3/4” (19mm) washer – large enough to seal the pre-drilled hole and to allow for movement.